Sensors For Arduino

Flame Sensor Module

Posted On July 6, 2019 at 10:22 am by / Comments Off on Flame Sensor Module

The flame sensor module detects wavelengths from 760nm-1100nm. The are other sources of heat that will also detect this wavelength. It is therefore important that you ensure that the only source of this particular range will be the flame that you want to detect.

Features:
– With output instructions
– Single output
– The output valid signal is low
– For the detection wavelength at 760 nm to 1100 nm range of the heat 
– The detection angle of 60 degrees
– The output switch circuit boards! (MCU can be connected directly)

Specifications:
– Size: 32 x 11 x 20mm 
– Main chip: LM393, infrared receiver 
– Operating voltage: DC 3-5V