Raspberry PI Board And Acceseories

Prototype Shield for Raspberry Pi

Posted On June 29, 2019 at 6:51 am by / Comments Off on Prototype Shield for Raspberry Pi

The Prototype development module is designed specifically for the Raspberry Pi. The module suitable enthusiasts and user can weld peripheral to the module;The module expand some amphenol connector and some SMT, so the user can finish prototype test easily.


— Expand common GPIO through amphenol connector

— Expand common GPIO through Female Header Connector

— Set aside a large amount of welding hole


— I2C amphenol connector

— Female Header Connector

— SPI amphenol connector

— SPI Female Header Connector

— Serial port amphenol connector

— Serial port Female Header Connector

— 3.3V Vcc

— 5V Vcc

Product Parameters:

— 3.5mm Amphenol Connector

— 2.54mm Female Header Connector

Typical Application:

— Hardware weld primer

— Prototype experiment

— DIY enthusiasts

How to use:

— Insert the Prototype development module to Raspberry Pi, Pay attention don’t make the direction reversed! The correct direction of insert module is above the Raspberry Pi’s PCB.